Industry News

When aluminum profiles are framed, there is a certain distance between materials

Update time : 2022-11-29 17:44:23

Some problems need to be paid attention to in the process of aluminum profile framing, the correct installation method should be used in the process of aluminum profile framing. The operation mode, processing technology, size and so on are different for different materials. The following describes the problems that need to be paid attention to when aluminum profile framing materials.

1. In the conveying frame, the material head and the contact mark should correspond to each other, the aluminum profiles can not touch each other, the length of the material should be well protected, so as not to wear each other; The aluminum profile should be swung straight back and forth, and the cutting surface should not be tilted. The wrapping condition of the raw strips and plastic parts on the surface of the frame should be checked to avoid rubbing with the exposed iron frame.

2. For aluminum profiles with different processing requirements and different materials such as oxidation, spraying, sandblasting, bending, punching, sawing and packaging, they should be respectively framed and run to avoid confusion.

3. When assembling the frame, pay attention to the way and method of assembling the frame, as well as the necessary auxiliary tools. The pad should be corresponding to the upper and lower, arranged neatly, the interval is appropriate, the number is appropriate, can withstand the weight and pressure of aluminum profiles, do not pile up too much, stack up, need to stack up overhead aluminum profiles.

4. Pay attention to the position of aluminum profiles stacked in the frame, so as not to weigh both ends, resulting in stacking and slipping of aluminum profiles. Pay attention to the cutting speed of the saw, saw cutting surface burr, observe the size of the saw machine oil injection, in order to adjust reasonably. When sawing, it is strictly prohibited to exert force on the two sides of the profile, so as to avoid the loss and danger caused by the aluminum profile clamping saw in the sawing process.

5. Pay attention to the aluminum chips to be blown clean, burrs to be scraped clean, spacing should be appropriate, and pay attention to the lifting installation, ensure the stacking frame alignment, the number of stacking frame should not exceed the specified 4 layers two requirements.

6. When lifting the frame, it should be light. For long materials, flat materials and other flexible materials, someone should lift them.

Previous : Aluminum profile development trend and related knowledge introduction

Next : The advantages and operation requirements of aluminum alloy profiles are shared

How to assemble and debug door and window aluminum profiles?

Jul .28.2023

The assembly and debugging of door and window aluminum profiles is one of the key links in the process of making doors and windows.

How to do a good job of cleaning industrial aluminum profiles?

Jul .17.2023

Spraying cleaning method of industrial aluminum profiles is widely used, because of complex equipment, high process requirements, poor cleaning effect, then how to better do spray cleaning of industrial aluminum profiles?

Aluminum extrusion profile six places are required during the stretching process

Jul .07.2023

The aluminum extrusion profile must be cooled to below 50 degrees before stretching. If the temperature is too high, stretching will not only burn the human body, the hair belt, but also expose absolute waste products such as bending, twisting, and poor performance before and after aging, because the stress in the aluminum alloy profile can not be completely eliminated.

Curtain wall aluminum profile purchase mainly see where?

Jul .06.2023

Appearance quality of curtain wall aluminum profile: the surface of anodic oxide film is not allowed to have electrical burns, oxide film falling off and other defects; Electrophoretic, powder, fluorocarbon profile paint film should be uniform, neat, smooth, do not allow wrinkles, cracks, bubbles, flow signs, inclusions and paint film fall off and other defects, but allow local film within 80 mm at the end of the profile.

Hammy Han