Industry News

What are the methods for cleaning industrial aluminum profile frames?

Views : 97
Update time : 2022-08-12 18:36:40
In the long-term use of the industrial aluminum profile frame, the surface will become dirty. At this time, we need to clean the industrial aluminum profile frame. We should pay attention to the appropriate method during the cleaning process, so that the cleaning of the industrial aluminum profile frame will Comparisons are quick and easy.
1. Strengthen workpiece inspection. The method of spray cleaning the industrial profile aluminum frame strictly implements the operating procedures. Check the running status every day and observe the process parameters all the time. It is forbidden for the workpiece to stagnate in the equipment to avoid rusting.
2. The formula of degreaser. Due to the poor effect of a single group of cleaning agents, multi-component and composite cleaning agents are generally used in the production of industrial aluminum profile frames. The cleaning agent can effectively exert its respective cleaning properties, so it can significantly improve the cleaning efficiency.
3. Foam and its control. In metal cleaning, the generation or removal of foam is very important to the pre-treatment process, and a certain amount of foam is beneficial to some treatment processes, but the quality of the cleaning agent does not depend on the amount of foam, but when spraying inside , the cleaning agent is required to be low-foaming, otherwise mass production cannot be carried out normally.
4. Pay attention to the quality of washing. In order to reduce the degree of pollution of the industrial aluminum frame, first of all, it should minimize the pollution of the workpiece entrained by the cleaning liquid to the next process. In addition, multi-stage washing should be considered, generally two-stage washing, and some processes still use pure water washing. The maximum contamination of the latter-stage washing water does not exceed one-tenth of the previous-stage cleaning workpiece, so that the residual liquid concentration of the second-stage washing workpiece is only 1% of the original concentration. When adding clean water to wash, use countercurrent supplement to save water.
Related News
Read More >>
How to assemble and debug door and window aluminum profiles? How to assemble and debug door and window aluminum profiles?
Jul .28.2023
The assembly and debugging of door and window aluminum profiles is one of the key links in the process of making doors and windows.
How to do a good job of cleaning industrial aluminum profiles? How to do a good job of cleaning industrial aluminum profiles?
Jul .17.2023
Spraying cleaning method of industrial aluminum profiles is widely used, because of complex equipment, high process requirements, poor cleaning effect, then how to better do spray cleaning of industrial aluminum profiles?
Aluminum extrusion profile six places are required during the stretching process Aluminum extrusion profile six places are required during the stretching process
Jul .07.2023
The aluminum extrusion profile must be cooled to below 50 degrees before stretching. If the temperature is too high, stretching will not only burn the human body, the hair belt, but also expose absolute waste products such as bending, twisting, and poor performance before and after aging, because the stress in the aluminum alloy profile can not be completely eliminated.
Curtain wall aluminum profile purchase mainly see where? Curtain wall aluminum profile purchase mainly see where?
Jul .06.2023
Appearance quality of curtain wall aluminum profile: the surface of anodic oxide film is not allowed to have electrical burns, oxide film falling off and other defects; Electrophoretic, powder, fluorocarbon profile paint film should be uniform, neat, smooth, do not allow wrinkles, cracks, bubbles, flow signs, inclusions and paint film fall off and other defects, but allow local film within 80 mm at the end of the profile.