Industry News

What are the commonly used cleaning methods in aluminum profile processing?

Views : 103
Update time : 2022-09-09 18:49:29
There are many different steps in the processing of aluminum profiles. Due to the needs of the operation, various isolation additives are used. In the subsequent processing process, the release agent or grease attached to the surface needs to be removed. However, due to the particularity of aluminum alloys, the use of general cleaning agents or improper handling will cause damage to the surface of aluminum alloys, and even corrode aluminum alloys. Therefore, there are many precautions to be aware of when cleaning aluminum alloys.
1. Selection of cleaning agent
In industrial production, a multi-component composite cleaning agent is generally selected. The composite cleaning agent made of strong alkali, weak alkali, polymeric inorganic salt, surface active agent, etc. can effectively exert its own cleaning characteristics, thereby significantly improving cleaning efficiency. .
2. Control of foam
In metal cleaning, foam is very important to the pretreatment process, and a certain amount of foam is beneficial to some pretreatment processes. However, the quality of industrial aluminum cleaning agent does not depend on the amount of foam, but when spraying in, it is required that the cleaning agent has a low foam, otherwise it is difficult to carry out mass production normally.
3. Pay attention to the quality of washing
In order to reduce the pollution degree, it is necessary to clean the cleaning liquid entrained in the workpiece to reduce the pollution degree to the next process. Generally, multi-stage washing is considered, and the pollution of the washing water in the latter stage should not exceed one tenth of the workpieces cleaned in the previous stage, which can also save water resources better.
4. Strict operation
Check the operating status of the equipment every day, and observe the process parameters at any time to avoid corrosion caused by the workpiece staying in the equipment for a long time.
Related News
Read More >>
How to assemble and debug door and window aluminum profiles? How to assemble and debug door and window aluminum profiles?
Jul .28.2023
The assembly and debugging of door and window aluminum profiles is one of the key links in the process of making doors and windows.
How to do a good job of cleaning industrial aluminum profiles? How to do a good job of cleaning industrial aluminum profiles?
Jul .17.2023
Spraying cleaning method of industrial aluminum profiles is widely used, because of complex equipment, high process requirements, poor cleaning effect, then how to better do spray cleaning of industrial aluminum profiles?
Aluminum extrusion profile six places are required during the stretching process Aluminum extrusion profile six places are required during the stretching process
Jul .07.2023
The aluminum extrusion profile must be cooled to below 50 degrees before stretching. If the temperature is too high, stretching will not only burn the human body, the hair belt, but also expose absolute waste products such as bending, twisting, and poor performance before and after aging, because the stress in the aluminum alloy profile can not be completely eliminated.
Curtain wall aluminum profile purchase mainly see where? Curtain wall aluminum profile purchase mainly see where?
Jul .06.2023
Appearance quality of curtain wall aluminum profile: the surface of anodic oxide film is not allowed to have electrical burns, oxide film falling off and other defects; Electrophoretic, powder, fluorocarbon profile paint film should be uniform, neat, smooth, do not allow wrinkles, cracks, bubbles, flow signs, inclusions and paint film fall off and other defects, but allow local film within 80 mm at the end of the profile.