Company News

Three methods of anodic oxidation hole sealing for industrial aluminum profiles

Views : 45
Update time : 2022-11-30 19:36:18
Under normal circumstances, after the production of industrial aluminum profiles need oxidation treatment, so that it can obtain a layer of protective film, which can make the service life of industrial aluminum profiles greatly extended. However, after aluminum oxidation processing, due to the porous structure and strong adsorption performance of the anodic oxidation film, the surface of industrial aluminum profiles is also easily contaminated, so it needs to be closed treatment.
When the oxide film hole is closed, different methods can be used to complete the requirements. In fact, for the oxidation processing of industrial aluminum profiles, there are three commonly used sealing methods, respectively: hot water sealing, steam sealing and salt solution sealing. The following are the main contents of these three methods respectively.
First, the hot water is closed. The main principle of this method is to hydrate the alumina on the surface of the oxide film and the pore wall in hot water, and then produce the hydrated alumina, so that the volume of the oxide film can be increased. In this way, the requirements of hole sealing can be realized. For industrial aluminum profile oxidation processing, the technical conditions of hot water sealing mainly include: the temperature is maintained at 95 ~ 100℃, the pH value is between 5.5 ~ 6, and the time is 10 ~ 30 minutes.
So, what does the second approach consist of? Comparatively speaking, this method is a little more effective than the first method, but the cost is also higher. Under normal circumstances, this sealing method is mainly used in the oxidation processing of industrial aluminum profiles for high sealing requirements, such as some decorative parts and so on. The main technical conditions for steam sealing are: the temperature is 100 to 110℃, and the pressure should be controlled between 0.05 and 0.1MPa.
The last one is the salt solution sealing method. In fact, using this method to seal, then you can choose different chemicals to seal according to the need, such as dichromate sealing. Under normal circumstances, the sealing method of salt solution is mainly applied to the sealing treatment of industrial aluminum profiles after oxidation processing and coloring.
Related News
Read More >>
How to assemble and debug door and window aluminum profiles? How to assemble and debug door and window aluminum profiles?
Jul .28.2023
The assembly and debugging of door and window aluminum profiles is one of the key links in the process of making doors and windows.
How to do a good job of cleaning industrial aluminum profiles? How to do a good job of cleaning industrial aluminum profiles?
Jul .17.2023
Spraying cleaning method of industrial aluminum profiles is widely used, because of complex equipment, high process requirements, poor cleaning effect, then how to better do spray cleaning of industrial aluminum profiles?
Aluminum extrusion profile six places are required during the stretching process Aluminum extrusion profile six places are required during the stretching process
Jul .07.2023
The aluminum extrusion profile must be cooled to below 50 degrees before stretching. If the temperature is too high, stretching will not only burn the human body, the hair belt, but also expose absolute waste products such as bending, twisting, and poor performance before and after aging, because the stress in the aluminum alloy profile can not be completely eliminated.
Curtain wall aluminum profile purchase mainly see where? Curtain wall aluminum profile purchase mainly see where?
Jul .06.2023
Appearance quality of curtain wall aluminum profile: the surface of anodic oxide film is not allowed to have electrical burns, oxide film falling off and other defects; Electrophoretic, powder, fluorocarbon profile paint film should be uniform, neat, smooth, do not allow wrinkles, cracks, bubbles, flow signs, inclusions and paint film fall off and other defects, but allow local film within 80 mm at the end of the profile.