Industry News

Is it good to choose aluminum alloy profiles for the motor housing?

Update time : 2022-11-02 19:29:04

The aluminum alloy water-cooled motor casing takes away almost all the heat generated by the motor during operation through the continuous circulation of cooling water in the interlayer of the casing, so that the motor hardly emits heat to the outside world. Since the motor housing aluminum extrusions has such a significant cooling effect, we have omitted the cooling fan that comes with the traditional motor itself, which can not only reduce the noise caused by the motor, but also improve the efficiency of the motor, so that the motor itself the consumption of electricity is effectively reduced, and the motor runs for a long time, which can bring you very considerable economic benefits; the advantages of motor housing aluminum extrusions are light weight, good heat dissipation, good thermal conductivity, can be extruded and die cast, and good plasticity. The elongation rate is higher than that of iron, the noise is low, and the operation stability is good.

1. Good heat dissipation: During the working process of the motor, due to the high-speed operation of the motor, the high temperature generated by the motor itself needs to be released, and the heat capacity of aluminum is very strong, so manufacturers have to choose motor housing aluminum extrusions as the motor housing.

2. Make the motor lighter: Metal aluminum is lighter, and the weight of the whole machine can be reduced. Easy to install and carry.

3. Good plasticity: Motor housing aluminum extrusions is lighter than steel, has good thermal conductivity, good plasticity, can be die-cast and has higher elongation than iron.

4. Motor housing aluminum extrusions are light in weight, low in vibration, low in noise, and have the characteristics of waterproof, dustproof, anticorrosion, energy saving, high performance and long service life. It is a new environmentally friendly product that cannot be replaced by ordinary motors.

Previous : The specific introduction of aluminum alloy profiles

Next : Introduction to the production process of aluminum window shutters

How to assemble and debug door and window aluminum profiles?

Jul .28.2023

The assembly and debugging of door and window aluminum profiles is one of the key links in the process of making doors and windows.

How to do a good job of cleaning industrial aluminum profiles?

Jul .17.2023

Spraying cleaning method of industrial aluminum profiles is widely used, because of complex equipment, high process requirements, poor cleaning effect, then how to better do spray cleaning of industrial aluminum profiles?

Aluminum extrusion profile six places are required during the stretching process

Jul .07.2023

The aluminum extrusion profile must be cooled to below 50 degrees before stretching. If the temperature is too high, stretching will not only burn the human body, the hair belt, but also expose absolute waste products such as bending, twisting, and poor performance before and after aging, because the stress in the aluminum alloy profile can not be completely eliminated.

Curtain wall aluminum profile purchase mainly see where?

Jul .06.2023

Appearance quality of curtain wall aluminum profile: the surface of anodic oxide film is not allowed to have electrical burns, oxide film falling off and other defects; Electrophoretic, powder, fluorocarbon profile paint film should be uniform, neat, smooth, do not allow wrinkles, cracks, bubbles, flow signs, inclusions and paint film fall off and other defects, but allow local film within 80 mm at the end of the profile.

Hammy Han