Company News

Industrial aluminum profile hard too low how to solve

Update time : 2022-11-07 19:20:20

In the production and processing of industrial aluminum profile, how to control the hardness is the key, a little unqualified, will bring trouble to the user, so how to solve the industrial aluminum profile hardness is too low?

1, aluminum extrusion frame can not be too dense, there should be an interval between the material and the material, especially the unventilated small material, thick material interval is more larger, tube material and small material, sheet material together with a frame, tube material put below this is conducive to aging circulation air supply.

2, temperature setting and control: usually, the thermometer shows that there is a certain error in the temperature, the table temperature should be set according to the actual temperature of the furnace, and pay close attention to the fluctuation of the temperature.

3, aluminum profile aging insulation: in strict accordance with the process requirements for aging, insulation time should be appropriate, to prevent aging is not enough or more than aging and hardness is not enough.

4. Before the aluminum profile is loaded into the furnace, the other special alloy of the 6 series and the ordinary 6063 alloy should be separately loaded into the furnace for aging. Due to the production reasons, the aging in the same furnace is indeed required, and the process of special alloy should be used for aging.

Extruded aluminum profiles, without aging before the hardness is too low to be used as finished products, therefore, generally speaking, must be aging to improve strength. Usually, the aging can be divided into natural aging and artificial aging two kinds, at present, the production of 6 series aluminum profiles is mainly based on the latter.

Previous : Causes and solutions of residual air in extrusion of aluminum profiles

Next : Aluminum profile encountered problems and solutions

How to assemble and debug door and window aluminum profiles?

Jul .28.2023

The assembly and debugging of door and window aluminum profiles is one of the key links in the process of making doors and windows.

How to do a good job of cleaning industrial aluminum profiles?

Jul .17.2023

Spraying cleaning method of industrial aluminum profiles is widely used, because of complex equipment, high process requirements, poor cleaning effect, then how to better do spray cleaning of industrial aluminum profiles?

Aluminum extrusion profile six places are required during the stretching process

Jul .07.2023

The aluminum extrusion profile must be cooled to below 50 degrees before stretching. If the temperature is too high, stretching will not only burn the human body, the hair belt, but also expose absolute waste products such as bending, twisting, and poor performance before and after aging, because the stress in the aluminum alloy profile can not be completely eliminated.

Curtain wall aluminum profile purchase mainly see where?

Jul .06.2023

Appearance quality of curtain wall aluminum profile: the surface of anodic oxide film is not allowed to have electrical burns, oxide film falling off and other defects; Electrophoretic, powder, fluorocarbon profile paint film should be uniform, neat, smooth, do not allow wrinkles, cracks, bubbles, flow signs, inclusions and paint film fall off and other defects, but allow local film within 80 mm at the end of the profile.

Hammy Han