Company News

Four points should be paid attention to in the process of aluminum profile oxidation post treatment

Views : 84
Update time : 2022-11-09 18:37:55
1. Rinse with hot water. Hot water washing is intended to age the film layer. But the water temperature and time should be strictly controlled, the water temperature is too high, the film thin, the color becomes lighter. Industrial aluminum profile processing time is too long will also appear the above similar problems, the appropriate temperature and time is: temperature 40 ~ 50℃ time 0.5 ~ 1MIN.
2. Dry. It is better to dry naturally. The workpiece washed by hot water is hung slanted on the shelf, so that the free water on the working surface flows down in a vertical direction. Flow to the lower corner of the water with a towel to absorb, according to this method of drying film color is not affected, appears natural.
3. Aging. Aluminum profile aging method can be determined according to climate conditions, there is sunlight in summer can be exposed in the sun, rainy days or winter can be baked in the oven, the process conditions are: temperature 40 ~ 50℃ time 10 ~ 15min.
4. Repair of unqualified parts. Unqualified conductive oxide membrane parts should be picked out before drying and ageing handle, because the membrane layer is difficult to eliminate after drying and ageing and will influence the roughness of the workpiece surface. This problem in the process of some exploration, through a variety of methods test, it is found that the following method is very good, simple method, and does not affect the surface exterior of the workpiece, the concrete process is as follows.
First of all, the unqualified workpiece is clamped on the fixture used for aluminum anodizing, and then let the aluminum in sulfuric acid solution anodizing method for anodizing 2 ~ 3min, until the film is soft, off, and then after a little alkaline cleaning and nitric acid light can be re conductive anodizing.
Related News
Read More >>
How to assemble and debug door and window aluminum profiles? How to assemble and debug door and window aluminum profiles?
Jul .28.2023
The assembly and debugging of door and window aluminum profiles is one of the key links in the process of making doors and windows.
How to do a good job of cleaning industrial aluminum profiles? How to do a good job of cleaning industrial aluminum profiles?
Jul .17.2023
Spraying cleaning method of industrial aluminum profiles is widely used, because of complex equipment, high process requirements, poor cleaning effect, then how to better do spray cleaning of industrial aluminum profiles?
Aluminum extrusion profile six places are required during the stretching process Aluminum extrusion profile six places are required during the stretching process
Jul .07.2023
The aluminum extrusion profile must be cooled to below 50 degrees before stretching. If the temperature is too high, stretching will not only burn the human body, the hair belt, but also expose absolute waste products such as bending, twisting, and poor performance before and after aging, because the stress in the aluminum alloy profile can not be completely eliminated.
Curtain wall aluminum profile purchase mainly see where? Curtain wall aluminum profile purchase mainly see where?
Jul .06.2023
Appearance quality of curtain wall aluminum profile: the surface of anodic oxide film is not allowed to have electrical burns, oxide film falling off and other defects; Electrophoretic, powder, fluorocarbon profile paint film should be uniform, neat, smooth, do not allow wrinkles, cracks, bubbles, flow signs, inclusions and paint film fall off and other defects, but allow local film within 80 mm at the end of the profile.